KAM / Reinforcement / adhesin mortar for thermal insulation panels

• For gluing and reinforcing stone wool and polystyrene thermal insulation panels
• Can be used for filling aerated concrete and silicate blocks
• Cement based
• Reinforced with polypropylene fibre
• With adhesion and flexibility improving additives
• Relatively longer processing time
• Water vapor permeable
• Water and frost resistant
• White colour

Processing 

Surface preparation
• The base must be dry and firm, all cracks and voids must be filled
• Clean the surface from loose and/or separable layers
• Particularly dense and/or smooth surfaces should be treated with an abrasive material
• Highly absorbent surfaces must be primed with SAKRET BG primer or SAKRET UG primer (diluted 1:3)
Reinforcement of thermal insulation panels
• Apply SAKRET KAM on the heat insulation panel in an even layer (up to 5mm), pull it out with a toothed trowel, embed the alkali-resistant reinforcing mesh in the mass and level it with the flat trowel so that the reinforcing mesh is completely covered with SAKRET KAM
• If the thermal insulation board is made of mineral wool, then first rub SAKRET KAM on the surface of the board
Adhesion of heat insulation panels
• If the wall is flat (unevenness <10mm/m), then apply SAKRET KAM with a toothed spatula (tooth size - 10mm) on the entire surface of the thermal insulation panel and stick it to the base
• If the wall is uneven, then apply SAKRET KAM on the edges of the thermal insulation panels (~5cm wide and 2cm high) and put 6 balls of material on the surface of the panels, then stick to the wall
• If the thermal insulation panel is made of mineral wool, then first rub SAKRET KAM on the surface of the panel

Packing

• 25 kg / paper bags / 48 bags on a pallet
• 1,000 kg / Big Bag packaging / pre-order
• 10,000 kg - 20,000 kg / mobile transport silo

Tehnical data 

Chemical composition: cement, special inert additives, auxiliary materials and auxiliary substances for improving processing properties