Menu
thumbSakret

FKe / Tile Adhesive Extra (grey, class C2TE)

  • For tiling on plasterboard, old tiles, and waterproofing SAKRET OAD ELASTIC
  • For ceramic and stone mass tiles, stone finishing plates, clinker tiles
  • Can be used on heated floors
  • Frost-resistant and moisture-resistant

Processing

  • The base must be dry and firm, all cracks and voids must be filled
  • Clean the Base surface from less persistent and/or separable layers
  • Especially dense and/or smooth surfaces must be scraped
  • Surfaces must be primed with SAKRET UG primer (diluted in a ratio of 1:3)
  • Especially smooth concrete surfaces should be primed with SAKRET QG primer
  • Mix SAKRET FKE in a clean container with cold water until a homogeneous mass without lumps is formed
  • It is recommended to use a mixer with 600 revolutions per minute
  • After the ripening time (~3 minutes) mix again
  • In one pass, cover as much surface area with glue as it is possible to cover with tiles in 15 minutes at a time
  • Deformation joints must not be filled with tile adhesive
  • Do not perform tiling work in direct sunlight, drafts and on wet surfaces
  • The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
  • During the hardening phase, protect the tile adhesive from the sun, drafts, frost and excessively high temperatures (>25°C)
  • Hardened tile adhesive can only be removed mechanically
  • Contains cement, reacts alkaline
  • Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
  • Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately

Packing

  • 5 kg / paper bags / 200 bags per pallet
  • 5 kg / paper bags / 60 bags on a pallet
  • 25 kg / paper bags / 48 bags on a pallet
  • 1,000 kg / Big-Bag packaging / pre-ordered
  • 10,000 kg - 20,000 kg / mobile transport silos

Tehnical data

Storage timeCompositionSticking time for applied adhesiveConsumption per m² (for 4x4 mm toothed trowel)Consumption per m² (for 6x6 mm toothed trowel)Consumption per m² (for 8x8 mm toothed trowel)Consumption per m² (for 10x10 mm toothed trowel)Compliant with the standardMay walk and fill groutsFire safety class
12 monthsCement, special inert additives, auxiliaries and auxiliary materials for improving processing properties~ 20 min.1,6 kg2,4 kg3,1 kg3,9 kgLVS EN 12004After ~ 24 hEuroclass A1 (non-flammable)
Back to Top