FKe / Tile Adhesive Extra (grey, class C2TE)

• For tiling on plasterboard, old tiles, and waterproofing SAKRET OAD ELASTIC
• For ceramic and stone mass tiles, stone finishing plates, clinker tiles
• Can be used on heated floors
• Frost-resistant and moisture-resistant

Processing

• The base must be dry and firm, all cracks and voids must be filled
• Clean the Base surface from less persistent and/or separable layers
• Especially dense and/or smooth surfaces must be scraped
• Surfaces must be primed with SAKRET UG primer (diluted in a ratio of 1:3)
• Especially smooth concrete surfaces should be primed with SAKRET QG primer
• Mix SAKRET FKE in a clean container with cold water until a homogeneous mass without lumps is formed
• It is recommended to use a mixer with 600 revolutions per minute
• After the ripening time (~3 minutes) mix again
• In one pass, cover as much surface area with glue as it is possible to cover with tiles in 15 minutes at a time
• Deformation joints must not be filled with tile adhesive
• Do not perform tiling work in direct sunlight, drafts and on wet surfaces
• The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
• During the hardening phase, protect the tile adhesive from the sun, drafts, frost and excessively high temperatures (>25°C)
• Hardened tile adhesive can only be removed mechanically
• Contains cement, reacts alkaline
• Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
• Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately

Packing

• 5 kg / paper bags / 200 bags per pallet
• 5 kg / paper bags / 60 bags on a pallet
• 25 kg / paper bags / 48 bags on a pallet
• 1,000 kg / Big-Bag packaging / pre-ordered
• 10,000 kg - 20,000 kg / mobile transport silos

Tehnical data