FKW / Tile Adhesive Extra (white, class C2 TE)

• For marble elements and finishing plates, glass mosaic, ceramic and stone mass tiles, stone finishing plates, fireplace finishing tiles, clinker tiles
• For tiling on old plasterboard tiles and waterproofing SAKRET OAD Elastic
• Can be used on heated floors
• Frost-resistant and moisture-resistant

Processing

Surface preparation

• The base surface must be dry and firm, all cracks and voids must be filled
• Clean the surface from less persistent and/or separable layers
• Especially dense and/or smooth surfaces must be scraped
• Surfaces must be primed with SAKRET UG primer (diluted in the ratio 1:3). Especially smooth concrete surfaces should be primed with SAKRET QG primer

Usage

• Mix SAKRET FKW in a clean container with cold water until a homogeneous mass without lumps is formed
• It is recommended to use a mixer with 600 turns per minute
• After ripening time ~3 min. mix again
• In one go, cover as much surface area with glue as can be covered with tiles in 15 min. at a time
• Deformation joints must not be filled with tile adhesive
• Hardened tile adhesive can only be removed mechanically

Instructions

• The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
• During the hardening phase, protect the tile adhesive from the sun, drafts, frost and excessively high temperatures (>25°C)
• Contains cement, reacts alkaline
• Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
• Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately

Packing

• 5 kg / paper bags / 200 bags per pallet
• 25 kg / paper bags / 48 bags on a pallet
• 1,000 kg / Big-Bag packaging / pre-ordered
• 10,000 kg - 20,000 kg / mobile transport silo

Tehnical data