SAKRET piedāvā dažāda veida lietošanai gatavos būvmaisījumus un būvķīmiju, nodrošinot to nemainīgu kvalitāti. Izmantojot laboratoriju tehnoloģiskās iespējas, kā arī kvalificētus un pieredzējušus speciālistus, uzņēmums pastāvīgi izstrādā jaunus produktus, ievērojot augstākās kvalitātes prasības un servisa līmeni.
For tiling on concrete, stable mineral surfaces and plasterboard
For internal and external works
Processing
The base surface must be dry and firm, all cracks and voids must be filled
Clean the surface from less persistent and/or separable layers
Particularly dense and/or smooth surfaces should be treated with an abrasive material
Surfaces must be primed with SAKRET UG primer (diluted in a ratio of 1:3)
Especially smooth concrete surfaces should be primed with SAKRET QG primer
Mix SAKRET FK Plus in a clean container with cold water until a homogeneous mass without lumps is formed
It is recommended to use a mixer with 600 turns per minute
After the ripening time (~3 minutes) mix again
In one pass, cover with adhesive as much surface area as it is possible to cover with tiles in 20 min. at a time
Deformation joints must not be filled with tile adhesive
Do not perform tiling work in direct sunlight, drafts and on wet surfaces
The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
During the hardening phase, protect the tile adhesive from the sun, drafts, frost and excessively high temperatures (>25°C)
Hardened tile adhesive can only be removed mechanically
Contains cement, reacts alkaline
Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately