BAM / Levelling compound for floors

• For levelling of floors (3 - 40mm)
• For levelling of floors before final finishing
• Can be used as a finishing coating for lightly loaded surfaces
• For levelling of full and partial horizontal planes
• For creating of slopes
• For repairing of defects in concrete foundations
• Suitable for heated floors
• Frost and moisture resistant
• To be levelled mechanically
• Cement based

Processing

Surface preparation

• The base surface must be dry and firm, all cracks and voids must be filled
• Clean the surface from loose and/or separable layers
• Absorbent surfaces must be primed with SAKRET UG primer (diluted 1:2)
• Dry and highly absorbent surfaces must be primed twice!
• Mass for floors can be used on concrete and other mineral materials’ foundations
• It is forbidden to use SAKRET BAM on gypsum or anhydride base surfaces!
• When using on heated floors, the heating must be turned off 5 days before and must not be turned on 28 days after the application of the material!

Usage

• Mix SAKRET BAM in a clean container with cold water until a homogeneous mass without lumps is formed
• It is recommended to use a mixer with 600 turns per minute
• After ripening time ~3 min. mix again
• Do not dilute the mass that has started to bind with water, but mix it again with a mixer
• Pour the mass on the surface (layer thickness ≥3mm) and level it
• Floor deformation joints must not be filled with levelling compound
• When levelling the base surfaces, the amortizing material should be incorporated around the perimeter
• When using material for levelling bulk floors, it is obligatory to observe the intervals of floor deformation joints

Instructions

• The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
• Protect from the sun, draft, frost and excessively high temperatures (>25°C) during the hardening phase of the aligner.
• Hardened compound can only be cleaned mechanically
• Contains cement, reacts alkaline
• Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
• Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately

Packing

• 25 kg / paper bags / 48 bags on a pallet
• 1,000 kg / Big-Bag packaging / pre-ordered
• 10,000kg - 20,000kg / mobile transport silos

Tehnical data