Menu
thumbSakret

BAK-F / Reinforcement / adhesion mortar for use in low temperature conditions

  • For work at low air temperatures from 0°C to +20°C
  • For adhesion and reinforcement of stone wool and polystyrene thermal insulation panels
  • Cement based
  • Reinforced with polypropylene fibre
  • With adhesion and flexibility improving additives
  • Water vapor permeable. Water and frost resistant
  • Grey colour

Processing 

Surface preparation
• Surfaces must not be covered with frost, ice or snow and the surface temperature must be ≥2°C
• The base must be dry and firm, all cracks and voids must be filled
• Clean the substrate from loose and/or separable layers
• Particularly dense and/or smooth surfaces should be treated with an abrasive material
• Highly absorbent surfaces must be primed with SAKRET BG primer or SAKRET UG primer (diluted 1:3)
Reinforcement of thermal insulation panels
• Apply SAKRET BAK-F on the heat insulation plate in an even layer (up to 5mm), pull it out with a toothed trowel, embed the alkali-resistant reinforcing mesh in the mass and level it with the flat trowel so that the reinforcing mesh is completely covered with SAKRET BAK-F
• If the thermal insulation panel is made of mineral wool, then SAKRET BAK-F is first rubbed into the surface of the board
Adhesion of heat insulation panels
• If the wall is flat (unevenness <10mm/m), then apply SAKRET BAK-F with a toothed spatula (tooth size - 10mm) on the entire surface of the thermal insulation board and stick it to the base
• If the wall is uneven, then apply SAKRET BAK-F to the edges of the thermal insulation plates (~5cm wide and 2cm high) and put 6 balls of the material on the surface of the plates, then stick to the wall
• If the thermal insulation panel is made of mineral wool, then SAKRET BAK-F is first rubbed into the surface of the panel

Packing

  • • 25 kg / paper bags / 48 bags on a pallet
    • 1,000 kg / Big Bag packaging / pre-order
    • 10,000 kg - 20,000 kg / mobile transport silo

Tehnical data 

Chemical composition: cement, special inert additives, auxiliaries and adjuvants for improving treatment properties

Atbilst standartamPatēriņš līmēšanaiPatēriņš armēšanaiUgunsdrošības klaseStorage time
LVS EN 998-1~4 - 6 kg/m²~4 - 7 kg/m²Eiroklase A1 (nedegošs)6 mēneši
Back to Top