ZM / Cement mortar
- For brick and block masonry
- Cement base
- Strength class M10
- For masonry, plastering and repair works
- Plastic
- Excellent mechanical and climatic resistance
- Especially suitable for wet rooms
- Can be used for masonry of chimneys
- In grey or white colour
- High hydrophobicity and water vapor permeability
Processing
- The foundation must be dry and firm, all cracks and voids must be filled
- Blocks or bricks must be clean and dry
- Clean the foundation from less persistent and/or separable layers
- Particularly dense and/or smooth foundations should be treated with an abrasive material
- Highly absorbent surfaces must be primed with SAKRET BG primer or SAKRET UG primer (diluted 1:3)
- Especially smooth concrete surfaces should be primed with SAKRET QG primer
- Mix SAKRET ZM in a clean container with cold water until a homogeneous mass without lumps is formed
- It is recommended to use a mixer with 600 turns per minute
- After the ripening time (~3 minutes) mix again
- The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
- During the hardening phase of the mortar, protect from the sun, drafts and excessively high temperatures (>30°C)
- Protect fresh adhesive from rain and too rapid drying
- When the mortar has started to bind, no more water can be added!
- Wash containers and tools with water immediately after processing the mortar
- Hardened mortar can only be removed mechanically
- Contains cement, reacts alkaline
- Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
- Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately
Packing
- 5 kg / paper bags / 60 bags on a pallet
- 25 kg / paper bags / 48 bags on a pallet
- 40 kg / / paper bags / 36 bags on a pallet
- 1,000 kg / BigBag packaging / pre-ordered
- 10,000 kg - 20,000 kg / mobile transport silo
Tehnical data
Achieving full hardness | Consumption | Storage time | Strength class | Strength class (according to LVS EN 998-2) | Grain size | Volume of ready mortar (25 kg) | Volume of ready mortar (40 kg) | pH | Drying for 1mm plaster layer |
---|---|---|---|---|---|---|---|---|---|
After 28 days | ~17 kg/m² (if the layer thickness is 10mm) | 12 months | CS IV | M10 | ≤2mm | ~ 15 l | ~ 24 l | 11 - 13,5 | 24 h |