NSP / Fast-hardening, Self-levelling compound for floors

• For laying of floors (3 - 20 mm)
• For levelling of full and partial horizontal surfaces
• For concrete bases
• Can be used on heated floors
• Cement based
• Before applying the finish coat
• For internal work

Processing 

• The base must be dry and firm, all cracks and voids must be filled
• Clean the surface from loose and/or separable layers
• Absorbent surfaces must be primed with SAKRET UG primer (diluted 1:2)
• Dry and highly absorbent surfaces must be primed twice!
• Mass floors can be used on concrete and other mineral materials
• It is forbidden to use SAKRET NSP on gypsum or anhydride bases!
• When using SAKRET NSP on heated floors, the heating must be turned off 5 days before and must not be turned on 28 days after the application of the material!
• Mix SAKRET NSP in a clean container with cold water until a homogeneous mass without lumps is formed
• It is recommended to use a mixer with 600 turns per minute
• After the ripening time (~3 minutes) mix again
• Do not dilute the material that has started to bind with water, but mix it again with a mixer
• Pour the mass on the surface (layer thickness >3mm) and level with a needle roller
• Floor deformation joints must not be filled with screed
• When levelling the bases, the amortizing material should be embedded along the perimeter
• When using material for levelling of bulk floors, it is obligatory to observe the intervals of floor deformation joints
• The technical data refers to a temperature of +20°C and 50% relative air humidity. Lower temperature increases, higher - decreases the specified values
• Protect from the sun, draft, frost and excessively high temperatures (>25°C) during the hardening phase of the leveller.
• Hardened mass can only be cleaned mechanically
• Contains cement, reacts alkaline
• Protect skin and eyes, follow technical instructions. If the mortar gets into the eyes, rinse with a large amount of water, if necessary, consult a doctor
• Protect the packaging from weather conditions, store on wooden pallets, in a cool and dry place, cover torn packaging immediately

Packing

• 25 kg / paper bags / 48 bags on a pallet
• 1,000 kg / Big-Bag packaging / pre-ordered
• 10,000 kg - 20,000 kg / mobile transport silos

Tehnical data